Windscreen wiper
If the jet of fluid is inadequate, firstly check that there is fluid in the reservoir: see “Checking fluid levels” in this section).
Then check that the nozzle holes are not clogged, if necessary use a needle.
The windscreen jets are directed by adjusting the angle of the nozzles: turn the nozzle cylinder by inserting a screwdriver in (A).
Fluid jets shall be directed at about 1/3 height from the window upper edge.
Rear window wiper
Rear window washer jets can be adjusted in the same way. The nozzle holder is on the rear window.
Nissan Micra. Heater operation
Heating
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets.
Move the air intake lever to the
position
for normal heating.
Turn the a ...
Mazda 2. i-stop
The i-stop function automatically stops the engine when the vehicle is
stopped at a traffi c
light or stuck in traffi c, and then restarts the engine automatically to resume
driving. The
system ...
Chevrolet Sonic. Cruise Control
If the vehicle is equipped with cruise control, a speed of about 40 km/h (25
mph) or more can be maintained without keeping your foot on the accelerator. Cruise
control does not work at speeds bel ...