When the parking lights are turned on and the
ignition switch is in ON , you can
use the
(select/reset) knob to adjust
instrument
panel brightness.
Brighten
: Turn the knob to the right.
Dim
: Turn the knob to the left.
You will hear a beep when the brightness reaches minimum or maximum. The information display will return to its original state several seconds after you adjust the brightness.
■ Brightness level indicator
The brightness level is shown on the information display while you are adjusting it.
Pressing the knob switches the
display.
If you turn the knob to the right until the brightness display is up to max, the beeper sounds. This cancels the reduced instrument panel brightness when the exterior lights are on.
The brightness can be set differently for when the exterior lights are on, and when they are off.
Honda Fit. Accessories
When installing accessories, check the following:
• Do not install accessories on the windshield. They can obstruct your view and
delay your reaction to driving conditions.
• Do not install acc ...
Mazda 2. Parking in an Emergency
Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway in an emergency.
The hazard warning lights warn other
drivers that your vehicle is ...
Fiat Punto. Bodywork
PROTECTION FROM ATMOSPHERIC
AGENTS
The main causes of corrosion are the following:
atmospheric pollution;
salty air and humidity (coastal areas, or hot humid
climates);
seasonal environmen ...