The following products and systems on your vehicle emit radio waves when in operation.
Each of the above complies with the appropriate requirements or the required standards of FCC (Federal Communications Commission) and Industry Canada Standard, described below:
As required by the FCC: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada Standard RSS-Gen/210/310.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Nissan Micra. Changing engine oil
Park the vehicle on a level surface and apply
the parking brake.
Start the engine and let it idle until it reaches
operating temperature, then turn it off.
Remove the oil filler cap A b ...
Peugeot 208. Programming
Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected
but is not switched on (PAUSE).
Set the programmed speed by accelerating to the required speed, then pre ...
Peugeot 208. Advice on care and maintenance
Recommendations on the care and maintenance your vehicle are given in the servicing
booklet.
Matt paint
If you vehicle is finished with a clear matt lacquer, please observe the following
recomme ...