
Visually check the brake/clutch fluid reservoir to make sure the fluid level is at the MIN (minimum) line on the side of the reservoir. The brake/ hydraulic clutch fluid system should be closed and sealed.
Do not remove the cap to check the fluid level or to top off the fluid level. Remove the cap only when necessary to add the proper fluid until the level reaches the MIN line.
Mazda 2. Blind Spot Monitoring (BSM) System
The Blind Spot Monitoring (BSM) system is designed to assist the driver in
checking the
area to the rear of the vehicle on both sides during lane changes by alerting
the driver to the
presence o ...
Fiat Punto. Starting procedure for petrol
versions
Proceed as follows:
Ensure that the handbrake is up;
Put the gear lever into neutral;
Press the clutch pedal down to the floor without
touching the accelerator;
Turn the ignition key to AV ...
Fiat Punto. Fuel consumption
The fuel consumption figures given in the table below are determined on the
basis of the homologation tests set
down by specific European Directives.
The procedures below are followed for measur ...