The High Beam Control System (HBC) determines the conditions in front of the vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically switch the headlights between high and low beams.
Refer to Warning/Indicator Lights on page 4-37 .
While driving the vehicle at a speed of about 30 km/h (18 mph), the headlights are switched to high beams when there are no vehicles ahead or approaching in the opposite direction.
The system switches the headlights to low beams when one of the following occurs:
The warning light fl ashes when the system has a malfunction.
Refer to Warning Lights on page 4-38 .
CAUTION
Do not adjust the vehicle height, modify the headlight units, or remove the camera, otherwise the system will not operate normally.
NOTE
The timing in which the system switches the headlights changes under the following conditions. If the system does not switch the headlights appropriately, manually switch between high and low beams according to the visibility as well as road and traffi c conditions.
To Operate the System
The High Beam Control System (HBC) operates to switch the headlights automatically between high and low beams after the ignition is switched ON and the headlight switch is in the AUTO and high beam position. At the same time, the High Beam Control System (HBC) indicator light (green) in the instrument cluster illuminates.
The High Beam Control System (HBC) determines that it is dark based on the brightness of the surrounding area.
NOTE
When the vehicle speed is less than about 20 km/h (12 mph), the High Beam Control System (HBC) switches the headlights to low beams.
Manual Switching
Switching to low beams
Shift the lever to the low beam position.
The High Beam Control System (HBC) indicator light (Green) turns off.
Switching to high beams
Turn the headlight switch to the
position.
The High Beam Control System (HBC)
indicator light (Green) turns off and the
is illuminated.
Peugeot 208. Unlocking the vehicle Complete unlocking
Using the key
Turn the key to the front of the vehicle to unlock the vehicle.
Using the remote control
Press the open padlock
to unlock the vehicle.
Unlocking is confirmed by rapid flashing of ...
Chevrolet Sonic. Tire Chains
Warning
Do not use tire chains. There is not enough clearance. Tire chains used on
a vehicle without the proper amount of clearance can cause damage to the brakes,
suspension, or other vehicle pa ...
Fiat Punto. To open the bonnet
Proceed as follows:
pull lever (A) in the direction of the arrow;
press lever (B) as shown by the arrow;
open the bonnet and release the rod (C) from its clip at the same
time. Insert the en ...