The ignition lock is designed so the key cannot be turned to the LOCK position and removed until the shift lever is placed in the P (Park) position.
When removing the key from the ignition switch, make sure the shift lever is in the P (Park) position.
If the shift lever is not returned to the P (Park) position, the ignition switch cannot be moved to the LOCK position.
To remove the key from the ignition switch:
If the shift lever is shifted to the P (Park) position after the ignition switch is turned to the OFF position or when the ignition switch cannot be turned to the LOCK position, proceed as follows to remove the key.
The shift lever is designed so it cannot be moved out of P (Park) and into any of the other gear positions if the ignition switch is turned to OFF position 1 or if the key is removed from the switch.
The shift lever can be moved if the ignition switch is in the ON position and the foot brake pedal is depressed.
There is an OFF position 1 between the LOCK and ACC positions. The OFF position is indicated by a “1” on the key cylinder.
Mazda 2. Parking Sensor System
The parking sensor system uses ultrasonic sensors to detect obstructions
around the vehicle
while parking the vehicle in a garage or during parallel parking when the shift
lever is
in reverse (R ...
Renault Clio. Five-door version
Side lights/brake and direction
indicator lights
Open the boot lid and remove screws 1.
The bulbs are under pressure
and can break when
replaced.
Risk of injury.
To re ...
Citroen C3. Airbags
System designed to maximise the safety
of the occupants (with the exception of
the rear centre passenger) in the event
of violent collisions. It supplements the
action of the force-limiting se ...