Activation
Switch off the ignition and get out of the vehicle.
Press the locking button
on the remote control.
The monitoring system
is active: the indicator lamp in the button flashes once per second.
After the locking button on the remote control is pressed, the exterior perimeter monitoring is activated after a delay of 5 seconds and the interior volumetric monitoring after a delay of 45 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a delay of 45 seconds at the same time as the interior volumetric monitoring.
Deactivation
Press the unlocking
button on the remote control.
The alarm system is
deactivated: the indicator lamp in the button goes off.
Honda Fit. Adding Engine Oil
1. Unscrew and remove the engine oil fill cap.
2. Add oil slowly.
3. Reinstall the engine oil fill cap, and tighten
it securely.
4. Wait for three minutes and recheck the
engine oil dipstick.
...
Chevrolet Sonic. Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
1. Back-up Lamp
2. Turn Signal Lamp
3. Stop Lamp/Taillamp
4. Sidemarker Lamp
To replace one of these bulbs:
1. Open the trunk.
2. Remove the ...
Peugeot 208. Particle emissions filter (Diesel)
The start of saturation of the particle filter is indicated by the temporary
illumination of this warning lamp accompanied by a warning message in the screen.
As soon as the traffic conditions pe ...