B-Class car manuals
Seat Ibiza: Rear seat bench -  Seats and stowage - Operating instructions - Seat Ibiza Owners Manual

Seat Ibiza: Rear seat bench

Seat Ibiza Owners Manual

Folding down rear seats


Fig. 77 Folding up the rear seat cushion


Fig. 78 Button for unlocking the rear backrest

Folding seat down

– Remove the head restraint. – Pull the front edge of the seat cushion ⇒ fig. 77 upwards in the direction of the
arrow. – Lift the cushion forwards
in the direction of the arrow.

– Pull the release button ⇒ fig. 78 in the direction of the arrow and fold the backrest forwards

– Insert the head restraints in their corresponding fastenings.

Folding seat forward

– Remove the head restraints from their fastening on the seat cushion. – Lift the backrest until it correctly engages in the catches. – Check that it has engaged correctly.

– Replace the rear head restraints. – Lower the cushion and push it backwards below the seatbelt buckles. – Press the front part of the cushion downwards.

On split rear seats  the backrest and cushion can be lowered and raised respectively in two sections.

WARNING

• Please be careful when folding back the backrest! Injuries can be caused if the backrest is tilted without due care and attention.

• Do no trap or damage seatbelts when raising the backrest.

• After raising the backrest, check it has engaged properly in position.

• The three point automatic seat belt only works correctly when the backrest of the central seat is correctly engaged.

    Front seats

    Stowage compartments

    Other info:

    Peugeot 208. Moving off
    Apply the parking brake. Select position P or N. Start the engine. If this procedure is not followed, there is an audible signal, accompanied by the display of an warning message. With ...

    Mazda 2. Radar Sensors (Rear)
    Your vehicle is equipped with radar sensors (rear). The following systems also use the radar sensors (rear). Blind Spot Monitoring system (BSM) Rear Cross Traffi c Alert (RCTA) The radar s ...

    Nissan Micra. Trip computer
    When the ignition switch is placed in the ON position, modes of the trip computer can be selected by pushing the trip computer change/reset button A on the instrument panel located near the speedo ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0081