A properly charged vehicle battery is essential for reliably starting the engine.
It is not necessary to disconnect the battery cables if you are recharging the vehicle battery using low amperages (for example from a mini-charger). Refer to the charger manufacturer's instructions.
A charging current of 0.1 multiple of the total vehicle battery capacity (or lower) must be used until full charging is achieved.
Both cables must be disconnected before charging the battery with high amperages, known as “rapid charging”.
The vent plugs of the vehicle battery should not be opened for charging.
WARNING
“Quick-charging” the vehicle battery is dangerous and requires a special charger and specialist knowledge.
CAUTION
On vehicles with the START/STOP system, the pole terminal of the charger must not be connected directly to the negative terminal of the vehicle battery, but only to the engine earth » page 165, Jump-starting in vehicles with the START-STOP system.
Note
We therefore recommend that vehicle batteries be rapid charged by a specialist garage.
Replacing
The new vehicle battery must have the same capacity, voltage, current and the same size as the original battery. Suitable vehicle battery types can be purchased from a specialist garage.
We recommend that the battery is replaced by a specialist garage, where the new vehicle battery will be installed properly and the original battery will be disposed of in accordance with national regulations.
Nissan Micra. USB (Universal Serial Bus) connection port
(if so equipped)
Connecting a device to the USB connection port
WARNING
Do not connect, disconnect, or operate the
USB device while driving. Doing so can be
a distraction. If distracted you could ...
Peugeot 208. Locking the vehicle Normal locking
Using the key
Turn the key towards the rear of the vehicle to lock the vehicle completely.
Using the remote control
Press the closed padlock
to lock the vehicle completely.
Maintaining ...
Renault Clio. Front seats
To move the seat forwards or backwards
Lift handle 1 to unlock. Release the
handle once the seat is in the correct
position and ensure that the seat is
locked.
For safety reasons, carr ...