Unscrew cap and check that the fluid level in the reservoir is at maximum.
Fluid level in the reservoir shall not exceed the MAX mark.
If fluid has to be added, it is suggested to use the brake fluid in table “Fluids and lubricants” (see chapter “Technical specifications”). When opening cap take the utmost care to prevent impurities entering the tank.
For topping up, always use a funnel with integrated filter with mesh equal to or lower than 0.12 mm.
IMPORTANT Brake fluid absorbs moisture; for this reason, if the car is mainly used in areas with a high degree of atmospheric humidity, the fluid should be replaced at more frequent intervals than specified in the “Service schedule”.
Make sure that the
highly corrosive brake fluid does not drip onto the paintwork. If it does, wash it off immediately with water. |
Brake fluid is poisonous
and highly corrosive. In the event of accidental contact, wash the parts involved immediately with neutral soap and water, then rinse thoroughly. Call the doctor immediately if the fluid is swallowed. |
The symbol
on the container indicates synthetic brake fluid, distinguishing it from the mineral kind. Using mineral fluids irreversibly damages the special braking system rubber seals. |
Chevrolet Sonic. Compass
The vehicle may have a compass display in the Driver Information Center (DIC).
The compass receives its heading and other information from the Global Positioning
System (GPS) antenna, StabiliTrak, ...
Peugeot 208. Resuming manual control
Depending on your requirements, you can make a different selection from that
offered by the system by changing a setting. The other functions will still be controlled
automatically.
Press the &qu ...
Nissan Micra. How to read the displayed lines
Guiding lines which indicate the vehicle width
and distances to objects with reference to the
vehicle body line A are displayed on the monitor.
Distance guide lines
Indicate distances from the ...