B-Class car manuals
Fiat Punto: Installing the tow hook - Towing trailers - Correct use of the car - Fiat Punto Owners Manual

Fiat Punto: Installing the tow hook

Fiat Punto Owners Manual

The towing device should be fastened to the body by specialised personnel according to any additional and/or integrative information supplied by the Manufacturer of the device.

The towing device must meet current regulations with reference to 94/20/EC Directive and subsequent amendments.

For any version the towing device used must match the towable weight of the vehicle on which it is to be installed.

For the electric connection a unified connector should be used which is generally placed on a special bracket normally fastened to the towing device, and a special ECU for external trailer light control shall be installed on the car.

For the electrical connection, a 7 or 13 pole 12ESP coupling must be used (CUNA/UNI and ISO/DIN standards). Follow the instructions provided by the car manufacturer and/or the tow hitch manufacturer.

An electric brake should be supplied directly by the battery through a cable with a cross section of no less than 2,5 mm2.

IMPORTANT Electric brake or other device shall be used with running engine.

In addition to the electrical branches, the car’s electric system can only be connected to the supply cable for an electric brake and to the cable for an internal light, though not above 15W.

For connections use a preset control unit with battery cable no less than 2,5 mm2.

Assembly diagram

The tow hook structure must be fastened in the points shown by the symbol using a total of 4 M8 screws 2
M10 screws and 2 M12 screws.

In the fastening points of the rear external covering, the dampening pad fastening plates must be replaced with right plate A and left plate B (code 50901257 and 50901258) that shall compulsorily be mounted in the external side of the rear covering, as shown in the figure.

The hook should be fastened to the body avoiding any type of drilling and trimming of the rear bumpers that remains visible when the hook is removed.

IMPORTANT It is compulsory to fasten a label (plainly visible) of suitable size and material with the following wording:

MAX LOAD ON BALL 60 kg

Assembly diagram


After fitting, screw
holes shall be sealed to prevent an exhaust gas inlet.
    Important notes

    Snow tyres

    Other info:

    Chevrolet Sonic. Roof
    Sunroof On vehicles with this feature, the sunroof only operates when the ignition is turned to ON/RUN or Retained Accessory Power (RAP) is active. Open/Close: To open the sunroof, press and hol ...

    Mazda 2. Lighting Control
    Headlights Turn the headlight switch to turn the headlights, other exterior lights and instrument panel illumination on or off. When the lights are turned on, the lights-on indicator light in t ...

    Skoda Fabia. Vehicle-specific details according to engine type
    The values specified have been determined in accordance with rules and under conditions set out by legal or technical requirements for determining operational and technical data for motor vehicle ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0084