B-Class car manuals
Mazda 2: Head Restraints - Seats - Essential Safety Equipment - Mazda2 Owners Manual

Mazda 2: Head Restraints

Mazda2 Owners Manual

Your vehicle is equipped with head restraints on front seats, rear outboard seats* and the rear centre seat * . The head restraints are intended to help protect you and the passengers from neck injury.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly adjusted.

In addition, always raise the head restraints mentioned below when they are being used: Driving with the head restraints adjusted too low or removed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

(Head restraints which must be raised for use)

  • All rear seat head restraints

Height Adjustment

Adjust the head restraint so that the centre is even with the top of the passenger's ears.

Height Adjustment


To raise a head restraint, pull it up to the desired position.

To lower the head restraint, press the stopcatch release, then push the head restraint down.

Front outboard seat

Front outboard seat


Rear outboard seat *

Rear outboard seat


Rear centre seat *

Rear centre seat


Removal/Installation

To remove the head restraint, pull it up while pressing the stop-catch.

To install the head restraint, insert the legs into the holes while pressing the stopcatch.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly installed: Driving with the head restraints not installed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

After installing a head restraint, try lifting it to make sure that it does not pull out: Driving with an unsecured head restraint is dangerous as the effectiveness of the head restraint will be compromised which could cause it to unexpectedly detach from the seat.

CAUTION

  • When installing a head restraint, make sure that it is installed correctly with the front of the head restraint facing forward. If the head restraint is installed incorrectly, it could detach from the seat during a collision and result in injury.
  • The head restraints on each of the front and rear seats are specialized to each seat. Do not switch around the head restraint positions. If a head restraint is not installed to its correct seat position, the effectiveness of the head restraint during a collision will be compromised which could cause injury.
    Rear Seat

    Seat Belt Systems

    Other info:

    Renault Clio. Bonnet
    To open the bonnet, pull the handle 1. Before performing any action in the engine compartment, the ignition must be switched off by pressing the engine stop button (please see ...

    Nissan Micra. Security systems
    Your vehicle has a security system: NISSAN Vehicle Immobilizer System NISSAN VEHICLE IMMOBILIZER SYSTEM The NISSAN Vehicle Immobilizer System will not allow the engine to start without t ...

    Chevrolet Sonic. DIC Operation and Displays
    The DIC has different displays which can be accessed by using the DIC buttons on the turn signal lever on the left side of the steering wheel. The DIC displays trip, fuel, and warning messages if ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0087