B-Class car manuals
Peugeot 208: Rear lamps - Changing a wheel - Practical information - Peugeot 208 Owners Manual

Peugeot 208: Rear lamps

Peugeot 208 Owners Manual


1. Brake lamps (P21W).

2. Reversing lamps (R10W).

3. Direction indicators (PY21W amber).

4. Sidelamps (light emitting diodes - LEDs).


5. Foglamp (P21W).

Changing the light emitting diode-LED lamps i

For replacement, contact a PEUGEOT dealer or qualified workshop.



Changing brake lamp, reversing lamp and direction indicator bulbs

These three bulbs are changed from inside the boot:

  • open the boot,
  • remove the access grille from the corresponding side trim panel,
  • slacken and remove the nut,
  • disconnect the lamp unit connector,
  • unclip the lamp unit carefully extract it pulling in line towards the outside,
  • press the four tabs and remove the bulb holder,
  • turn the bulb a quarter of a turn and change it.

To reassemble, carry out these operations in reverse order.

Take care to engage the lamp unit in its guides, while keeping it in line with the vehicle. Tighten sufficiently to ensure sealing, but without damaging the lamp.


Changing the third brake lamp bulbs

  • Unscrew the fixing pins on each side of the lamp, without removing them completely.
  • Push on the screws to unclip the lamp.
  • Disconnect the lamp connector.
  • Remove the lamp from the outside.
  • Turn the bulb holder which corresponds to the faulty bulb one quarter of a turn and remove it.
  • Pull the bulb and change it.

To refit, carry out these operations in reverse order.


Number plate lamps

To facilitate the removal of the lamp, carry out this operation with the tailgate half open.

  • Insert a thin screwdriver into the lens cutout.
  • Push it outwards.
  • Remove the lens.
  • Change the faulty bulb.

To refit, press on the lens to clip it in place.


Changing a foglamp bulb

Access is by passing a hand under the bumper.

  • Turn the bulb holder a quarter of a turn and pull it out.
  • Disconnect the connector on the bulb holder.
  • Pull the bulb out and change it.

To refit, carry out these operations in reverse order.

You can also contact a PEUGEOT dealer or a qualified workshop for the replacement of these bulbs.

    Front lamps

    Changing a fuse

    Other info:

    Chevrolet Sonic. Event Data Recorders
    This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road ...

    Mazda 2. Add-On Non-Genuine Parts and Accessories
    Please note that technical alterations to the original state of your Mazda vehicle can affect the safety of the vehicle. Such technical alterations include not only the use of unsuitable spare p ...

    Seat Ibiza. Brief introduction
    Why wear a seat belt and assume the correct sittingposition? For the inflating airbags to achieve the best protection, the seat belt must always be worn properly and the correct sitting position mu ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0088