Renault Clio: Gear lever/Handbrake

Gear lever

Renault Clio. Gear lever


Vehicles with manual gearbox: refer to the grid on the gear lever knob 1.

Vehicles with automatic gearbox: refer to the information on the “Automatic gearbox” in Section 2.

Selecting reverse gear The reversing lights will come on as soon as reverse gear is selected with the ignition on.

Handbrake

To release: Pull the lever 3 up slightly, press button 2 and then lower the lever to the floor.

The red warning light on the instrument panel will come on if you are driving with an incorrectly released handbrake.

To apply: Pull lever 3 upwards. Check that the vehicle is immobilised. The warning light on the instrument panel will
come on.

An impact to the underside of the vehicle while manoeuvring (e.g.: striking a post, raised kerb or other street furniture) may result in damage to the vehicle (e.g.: deformation of an axle).

To avoid any risk of accident, have your vehicle checked by an approved Dealer.

Make sure that the handbrake is fully released when driving (red indicator light off), otherwise overheating, or even damage, may occur.

When stationary, and depending on the slope and/or vehicle load, it may be necessary to pull up the handbrake at least two extra notches and engage a gear (1st or reverse gear) for vehicles with a manual gearbox or position P for vehicles with an automatic gearbox.

READ NEXT:

 Eco-driving

Fuel consumption is accredited in accordance with a standard regulatory method. Identical for all manufacturers, this enables vehicles to be compared with one another. Consumption in real time de

 Gear change indicator

Gear change indicator 1 To obtain optimum consumption levels, a warning light on the instrument panel lets you know the best time to move up or down a gear: move up a gear; move down a gea

 Journey record

Once the engine is switched off, you will see “Journey record” displayed on the screen 3, enabling you to view information relating to your last journey. This indicates: average fuel

SEE MORE:

 Sunroof mobile panel: Removal - Refitting

PANORAMIC SUNROOF REMOVAL I - REMOVAL PREPARATION OPERATION Open the moving panel. II - OPERATION FOR REMOVAL OF PART CONCERNED Remove the rear bolts (1) from the mobile panel. Remove: the mobile panel front bolts (2), the mobile panel (this operation requires two people). REFITT

 Turbocharging: Precautions for the repair

D4F or K9K I - TURBOCHARGER: GENERAL INSTRUCTIONS For the turbocharging pressure regulator check (see Fault finding - Tests) (Technical Note 3419A, 12B, Turbocharging). WARNING The turbocharger pressure regulator rod must not be adjusted. II - TURBOCHARGER CIRCUIT DIAGRAM Air filter unit Air fl

© 2016-2024 Copyright Renault Clio Owners Club