
If your vehicle is fi tted with an HDI engine, the fuel circuit must be reprimed if you run out of fuel.
This system consists of a repriming pump, a transparent pipe and a degas screw under the bonnet.
HDi 90 and HDi 110 FAP engines
If the engine does not start at the fi rst attempt, do not try again.
Operate the repriming pump again, then the starter.
Peugeot 208. Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...
Fiat Punto. Driving style
Starting
Do not warm the engine with the car at a standstill or
at idle or high speed: under these conditions the
engine warms up much more slowly, increasing
electrical consumption and emissions. ...
Peugeot 208. Leaving cruise control mode
Turn thumb wheel 1 to the "0" position: the cruise control mode is deselected.
The display returns to the distance recorder.
...