B-Class car manuals
Fiat Punto: Engine oil - Checking fluid levels - Car maiintenance - Fiat Punto Owners Manual

Fiat Punto: Engine oil

Fiat Punto Owners Manual

Checking engine oil

Check the oil level a few minutes (about 5) after the engine has stopped, with the car parked on level ground.

Check that the level is within the MIN and MAX marks on the dipstick.

The interval between the MIN and MAX marks corresponds to about one litre of oil.

1.28V versions
1.28V versions

Topping up engine oil

If the oil level is near or even below the MIN mark, add oil through the filler neck, until reaching the MAX mark. Oil level shall never exceed the MAX mark.

IMPORTANT If a routine check reveals that the oil level is above the MAX mark, contact Fiat Dealership to have the correct level restored.

IMPORTANT After adding or changing the oil, let the engine turn over for a few seconds and wait a few minutes after turning it off before you check the level.

1.3 Multijet versions
1.3 Multijet versions

Engine oil consumption

Max engine oil consumption is usually 400 grams every 1000 km.

When the car is new, the engine needs to run in, therefore the engine oil consumption can only be considered stabilised after the first 5000 - 6000 km.

IMPORTANT The oil consumption depends on driving style and the conditions under which the car is used.

IMPORTANT Do not add oil with specifications other than that already in the engine.

When the engine is hot,
take care when working inside the engine compartment to avoid burns. Remember that when the engine is hot, the fan may cut in: danger of injury. Scarves, ties and other loose clothing might be pulled by moving parts.

Used engine oil and
filter contain harmful substances for the environment.

Contact Fiat Dealership to have the oil and filter changed.

    Checking fluid levels

    Engine coolant fluid

    Other info:

    Fiat Punto. Extending the boot
    Single rear seat Proceed as follows: fasten the seat buckles to the tabs on the seat back (as shown by arrows); check that the webbing (A) of each of the two side seat belts is inserted int ...

    Mazda 2. i-Activsense
    i-ACTIVSENSE is a collective term covering a series of advanced safety and driver support systems which make use of detection devices such as the forward sensing camera (FSC) and radar sensors. ...

    Citroen C3. Jack socket
    This connection box, consisting of a JACK socket is located on the centre console. It permits the connection of portable equipment, such as a digital audio player of the iPod ® type. It r ...

    Manuals For Car Models


    © 2016-2025 Copyright www.b-auto.net 0.0103