B-Class car manuals
Fiat Punto: If an exterior light burns out - In an emergency - Fiat Punto Owners Manual

Fiat Punto: If an exterior light burns out

Fiat Punto Owners Manual

Fiat Punto / Fiat Punto Owners Manual / In an emergency / If an exterior light burns out

For the type of bulb and power rating, see “When needing to change a bulb”.

FRONT LIGHT UNITS

The front light units contain: sidelights, dipped beam, main beam and direction indicator bulbs.

The bulbs are arranged inside the light unit as follows:

  1. sidelights/main beam headlights;
  2. dipped beam headlights;
  3. direction indicators.

IMPORTANT After replacement, refit the covers correctly checking that they are properly secured.

Front light units


MAIN BEAM HEADLIGHTS

To change the bulb, remove the protective cover (1), release the catch (A) and remove the bulb (B).

Main beam headlights


DIPPED BEAM HEADLIGHTS

To change the bulb, remove the protective cover (2), release the catch (A) and remove the bulb (B).

Dipped beam headlights


FRONT SIDELIGHTS

To change the bulb, remove the protective cover (1), remove connector (A) and remove the bulb (B).

Front sidelights


DIRECTION INDICATORS

Front

To change the bulb, remove the protective cover (3), turn connector (A) clockwise and remove the bulb (B).

Direction indicators


Side

To change the bulb, proceed as follows:

  • Press the lens (A) in the direction of the arrow (opposite to running direction) so to compress the clip (B) and remove the cluster;
  • Turn the lens (A) counterclockwise and remove it; then remove the snap-fitted bulb (C).

Direction indicators


FRONT FOG LIGHTS

Go to a Fiat Dealership to have bulbs replaced.

Front fog lights


REAR LIGHT UNIT

To change the bulb, proceed as follows:

  • from inside the car, remove the upper plastic cover (A) with the screwdriver provided to reach fastener (B);
  • from inside the boot, fit extension (C) on the light cluster fastening nuts;
  • insert the provided screwdriver (D) in the hole in the extension and loosen the light cluster fastening nuts;
  • withdraw the connector and loosen the fastening screws shown in the figure by the arrows;
  • remove the bulbs by pushing them slightly and turning them anticlockwise (bayonet coupling).

Rear light unit


Rear light unit


The bulbs are arranged inside the light unit as follows:

  1. Side/taillight bulb
  2. Brake light bulb
  3. Direction indicator bulb
  4. Bulb for:
  • left-hand cluster: rear fog light
  • right-hand cluster: reversing light.

ADDITIONAL BRAKING LIGHT (THIRD STOP)

To change the bulb, proceed as follows:

  • open the tailgate and loosen screws (A);
  • release the clip (B) and open the bulb holder, the remove the bulb (C) to be replaced (clipped in).

Additional braking light


Additional braking light


NUMBER PLATE LIGHT

To change the bulb, proceed as follows:

  • release the tab (A) and remove the cluster;
  • turn the bulb holder (B) anticlockwise and remove the bulb (C).

Number plate light


Number plate light


    Types of bulbs

    If an interior light burns out

    Other info:

    Nissan Micra. Avoiding collision and rollover
    WARNING Failure to operate this vehicle in a safe and prudent manner may result in loss of control or an accident. Be alert and drive defensively at all times. Obey all traffic ...

    Honda Fit. Instrument Panel
    Gauges/Information Display/System Indicators Lights Reminders System Indicators System Indicators System Indicators System Indicators ...

    Peugeot 208. Operating fault
    With the ignition on, if this warning lamp comes on and AUTO flashes, accompanied by an audible signal and a message in the screen, this indicates a gearbox fault. Have it checked by a PEUGEOT d ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0097