B-Class car manuals
Mazda 2: Front Seat - Seats - Essential Safety Equipment - Mazda2 Owners Manual

Mazda 2: Front Seat

Mazda2 Owners Manual

Seat Operation

Seat Operation


  1. Seat Slide

To move a seat forward or backward, raise the lever and slide the seat to the desired position and release the lever.

Make sure the lever returns to its original position and the seat is locked in place by attempting to push it forward and backward.

  1. Height Adjustment (Driver's Seat)

To adjust the seat height, move the lever up or down.

  1. Seat Recline

To change the seatback angle, lean forward slightly while raising the lever. Then lean back to the desired position and release the lever.

Make sure the lever returns to its original position and the seatback is locked in place by attempting to push it forward and backward.

Seat Warmer

The front seats are electrically heated. The ignition must be switched ON.

Press the seat warmer switch to illuminate the indicator light while the ignition is switched ON. The mode changes as follow each time the seat warmer switch is pressed.

Seat Warmer


WARNING

Be careful when using the seat warmer: The heat from the seat warmer may be too hot for some people, as indicated below, and could cause a lowtemperature burn.

  • Infants, small babies, elderly people, and physically challenged people
  • People with delicate skin
  • People who are excessively fatigued
  • People who are intoxicated
  • People who have taken sleepinducing medicine such as sleeping pills or cold medicine

WARNING

Do not use the seat warmer with anything having high moistureretention ability such as a blanket or cushion on the seat: The seat may be heated excessively and cause a low-temperature burn.

Do not use the seat warmer even when taking a short nap in the vehicle: The seat may be heated excessively and cause a low-temperature burn.

Do not place heavy objects with sharp projections on the seat, or insert needles or pins into it: This could cause the seat to become excessively heated and result in injury from a minor burn.

CAUTION

Do not use organic solvents to clean the seat. It may damage the seat surface and the heater.

NOTE

  • If the ignition is switched off while the seat warmer is operating (High, Mid or Low) and then switched ON again, the seat warmer will automatically operate at the temperature set before switching off the ignition.
  • Use the seat warmer when the engine is running. Leaving the seat warmer on for long periods with the engine not running could cause the battery power to be depleted.
  • The temperature of the seat warmer cannot be adjusted beyond High, Mid and Low because the seat warmer is controlled by a thermostat.
    Seat Precautions

    Rear Seat

    Other info:

    Peugeot 208. Operation
    Going into engine STOP mode The "ECO" warning lamp comes on in the instrument panel and the engine goes into standby: - with a manual gearbox , at speeds below 12 mph (20 km/h), when yo ...

    Nissan Micra. Recommended fluids/lubricants and capacities
    The following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedure described in the “Maintenance and do-it-yourself” section ...

    Skoda Fabia. Wearing seat belts
    Introduction Fig. 3 Driver wearing seat belt Seat belts that are fastened correctly offer good protection in the event of an accident. They reduce the risk of an injury and increase the chanc ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0076