i-ELOOP is a regenerative braking system. When you depress the brake pedal or use engine braking, the kinetic energy that occurs is converted to electrical energy by the power generator and the converted electrical energy is stored in the storage device. The stored electricity is used as power to charge the battery and the vehicle's electrical devices.
CAUTION
High-current electricity fl ows through the following parts, therefore do not touch them.
NOTE
For details, go to the following URL.
http://www.mazda.com/csr/environment/recycling
i-ELOOP Indicator Light/Control Status Display
The driver is notifi ed of the i-ELOOP power generating status and the vehicle conditions by the i-ELOOP indicator light (green) and the control status display.
i-ELOOP Indicator Light (Green) (vehicle without type C/type D audio)
The light turns on during power
generation.
Control status display (vehicles with type C/type D audio)
The i-ELOOP power generating status is displayed in the centre display.
Refer to Control Status Display on page 4-90 .
Mazda 2. Key Battery Replacement
If the buttons on the transmitter are
inoperable and the operation indicator
light does not fl ash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
...
Renault Clio. To refit a wheel
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its ow ...
Renault Clio. Five door and estate versions
Reversing lights and rear fog
lights 12
Open the boot lid.
Unclip cover 13 and remove it.
Turn bulb holder 14 fully anticlockwise
and change the bulb.
To reassemble, proceed in the ...