Renault Clio: Roof bars/Spoiler
Accessing the mounting points
Open the doors to access the mounting points 1.
| If original roof bars, approved by our Technical Department, are supplied with screws, only use these screws for attaching the roof bars to the vehicle. |
Precautions during use
Handling the tailgate
Before handling the tailgate, check the objects and/or accessories (bike rack, roof box, etc.) fitted to the roof bars: these must be correctly positioned and secured, so as not to hinder the operation of the tailgate.
| For information on the range of
equipment adapted to your vehicle,
we advise you to consult an approved
Dealer. Refer to the manufacturer’s instructions for information on how to fit and use the roof rack bar. Please keep these instructions with the rest of the vehicle documentation. Maximum permissible load on roof rack: 80 kg (including the carrying device). |
Spoiler A
| It is forbidden to fix objects and/or accessories (bike racks, etc.) to the spoiler. |
READ NEXT:
Multimedia equipment
The presence and location of this equipment
depends on the vehicle version.
Multimedia touchscreen;
Multimedia sockets;
Steering column control;
Voice commands;
Microphone.
Refe
Maintenance
The maintenance of the Renault Clio IV (2014-2019) involves following the recommended guidelines provided in the owner's manual. Regular maintenance tasks include oil changes, filter replacements, and
Bonnet
To open the bonnet, pull the handle 1.
Before performing any
action in the engine compartment,
the ignition must
be switched off by pressing
the engine stop button (please see
SEE MORE:
Oil vapour rebreathing circuit: Descriptions
K4J or K4M, and 780 or 800 or 801
Oil vapour rebreathing duct
Calibrated port
Oil vapour recovery plate
located on the rocker cover
Oil vapour rebreathing hole
Oil vapour rebreathing circuit: Operating diagram
K4J, and 780 - K4M, and 800 or 801
A: under low loads, the oil vapours are rebr
Solenoid valve assembly pressure sensor: Removal - Refitting
K9K, and JA5
REMOVAL
REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydrauli
© 2016-2024 Copyright Renault Clio Owners Club
