Renault Clio: Tools

Renault Clio. Tools


The tools included in the tool kit depend on the vehicle.

Tool kit A is located in the tray under the luggage compartment carpet.

Lift the cover and remove it.

Wheelbrace 1

Renault Clio. Wheelbrace


Locks or unlocks the wheel bolts and tow eye 5

Jack 2

Fold it correctly before refitting it in its housing (ensure that the wheelbrace is correctly positioned).

Hubcap tool 3

This tool is used to remove the wheel trims.

Wheel bolt guide 4

To finish loosening or starting to tighten the wheel bolts.

Tow eye 5

Please see “Towing: breakdown recovery” in Section 5.

Lever 6

This tightens or releases the tow eye 5.

Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing: there is a risk of injury.

If wheel bolts are supplied in the tool kit, only use these bolts for the emergency spare wheel: refer to the label affixed to the emergency spare wheel.

The jack is designed for wheel changing purposes only. Under no circumstances should it be used for carrying out repairs underneath the vehicle or to gain access to the underside of the vehicle.

READ NEXT:

 Wheel trims - wheel

Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2. To refit it, align it with valve 2. Push the retaining hooks in fully,

 Changing a wheel

Switch on the hazard warning lights. Keep the vehicle away from traffic and on a level surface where it will not slip. Apply the parking brake and engage a gear (first or

 Tyres (tyre and wheel safety, use in winter)

Tyre and wheel safety The tyres are the only contact between the vehicle and the road, so it is essential to keep them in good condition. You must comply with the local rules given in the highway

SEE MORE:

 K9K, and JH3 or JR5 or TL4

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove the front engine cover. K9K, and 772 Discharge the pressure in the fuel supply circuit of the exhaust fuel injector (see 19B, Exhaust, Exhaust

 Centre console: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Remove the trim (1). Unclip the gear lever trim. II - OPERATION FOR REMOVAL OF PART CONCERNED Remove the bolts (2). Push the seats forward as far as possible. Remove the bolts (3). Take out the centre console (4). III - REFITTING OPERATION

© 2016-2024 Copyright Renault Clio Owners Club