When the parking lights are turned on and the
ignition switch is in ON , you can
use the
(select/reset) knob to adjust
instrument
panel brightness.
Brighten
: Turn the knob to the right.
Dim
: Turn the knob to the left.
You will hear a beep when the brightness reaches minimum or maximum. The information display will return to its original state several seconds after you adjust the brightness.
■ Brightness level indicator
The brightness level is shown on the information display while you are adjusting it.
Pressing the knob switches the
display.
If you turn the knob to the right until the brightness display is up to max, the beeper sounds. This cancels the reduced instrument panel brightness when the exterior lights are on.
The brightness can be set differently for when the exterior lights are on, and when they are off.
Fiat Punto. Using the manual gearbox
To engage the gears, press the clutch pedal fully and shift the gear lever
into one of the required positions (the diagram is shown on the knob).
IMPORTANT The car can only be put into reverse gea ...
Peugeot 208. Operating fault
When the ignition is on, the lighting
of this warning lamp, accompanied by an audible signal and a message in the multifunction
screen, indicates a gearbox fault.
In this case, the gearbox switc ...
Mazda 2. Interior Care
WARNING
Do not spray water in the cabin:
Splashing water on electrical parts
such as the audio unit and switches
is dangerous as it could cause a
malfunction or a fire.
Instrument panel Precauti ...