■Shift Lever Operation+
Fully depress the clutch pedal to operate the shift lever and change gears, then slowly release the pedal.
Depress the clutch pedal, and pause for a few seconds before shifting into
, or
shift into one of the forward gears for a moment. This stops the gears so they
do not
“grind.”
NOTICE
Do not shift to before the
vehicle comes to a
complete stop.
Shifting to before stopping can
damage the
transmission.
NOTICE
Before downshifting, make sure the engine will not go into the tachometer’s red zone. Should this occur, it can severely damage your engine.
When you are not shifting, do not rest your foot on the clutch pedal. This can cause your clutch to wear out faster.
Recommended Shift Points Driving in the highest gear that allows the engine to run and accelerate smoothly helps to optimize fuel economy and effective emissions control. The following shift points are recommended:
If you exceed the maximum speed for the gear you are in, the engine speed will enter into the tachometer’s red zone. When this happens, you may experience a slight jolt.
Peugeot 208. Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...
Chevrolet Sonic. Parking Brake
To set the parking brake, hold the brake pedal down and pull up on the parking
brake lever. If the ignition is on, the brake system warning light will come on.
See Brake System Warning Light.
T ...
Fiat Punto. Interior fittings
GLOVE COMPARTMENT
Operate handle (A) as shown by the arrow to open the compartment.
COIN TRAY
A coin tray may be found on the dashboard on the central tunnel
according to the versions.
MA ...