The ignition lock is designed so the key cannot be turned to the LOCK position and removed until the shift lever is placed in the P (Park) position.
When removing the key from the ignition switch, make sure the shift lever is in the P (Park) position.
If the shift lever is not returned to the P (Park) position, the ignition switch cannot be moved to the LOCK position.
To remove the key from the ignition switch:
If the shift lever is shifted to the P (Park) position after the ignition switch is turned to the OFF position or when the ignition switch cannot be turned to the LOCK position, proceed as follows to remove the key.
The shift lever is designed so it cannot be moved out of P (Park) and into any of the other gear positions if the ignition switch is turned to OFF position 1 or if the key is removed from the switch.
The shift lever can be moved if the ignition switch is in the ON position and the foot brake pedal is depressed.
There is an OFF position 1 between the LOCK and ACC positions. The OFF position is indicated by a “1” on the key cylinder.
Chevrolet Sonic. Lockout Protection
If the driver side power door lock switch is pressed when the driver door is
open and the key is in the ignition, all of the doors will lock and then the driver
door will unlock.
If Unlocked Door ...
Mazda 2. Seat Belt Precautions
Seat belts help to decrease the possibility of severe injury during accidents
and sudden
stops. Mazda recommends that the driver and all passengers always wear seat
belts.
Front seat and rear ou ...
Fiat Punto. To close the bonnet
Proceed as follows:
hold the bonnet up with one hand and, with the
other, remove rod (C) from recess (D) replace it in
its clip;
lower the bonnet at approx. 20 cm from the engine
compartme ...