Nissan Micra: Drive belt
Nissan Micra Owners Manual
HR16DE engine
- Water pump pulley
- Generator pulley
- Crankshaft pulley
- Air conditioner compressor pulley (if so equipped) /Idler pulley (if so equipped)
- Manual tensioner pulley
Tension checking point
| WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. |
- Visually inspect the belt for signs of unusual wear, cuts, or fraying. If the belt is in poor condition, have it replaced or adjusted by a NISSAN dealer.
- Have the belt checked regularly for condition.
Other info:
Nissan Micra. Air flow charts
The following charts show the button and dial
positions for MAXIMUM AND QUICK heating,
cooling or defrosting. The air intake lever
should always be in the position
for
heating and defrosting.
...
Ford Fiesta. Supplementary Restraints System
Principle of Operation
WARNINGS
Airbags do not inflate slowly or
gently, and the risk of injury from a
deploying airbag is the greatest close
to the trim covering the airbag module.
All occupants of ...
Peugeot 208. Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia
