Renault Clio: On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
Display selection keys 2 and 3
Scroll through the following information
upwards (key 2) or downwards (key 3)
by pressing briefly and successively
(the display depends on the vehicle
equipment and country).
- total mileage and trip mileage recorder;
- fuel used;
- average fuel consumption;
- current fuel consumption;
- estimated range;
- distance travelled;
- average speed;
- distance before service;
- service counter;
- oil change counter;
- Reset the tyre pressure
- Cruise control and speed limiter programmed
speed
- Clock and temperature
- Trip log, operating faults and information
message readout
Resetting the trip mileage
With “trip mileage recorder” selected on
the display, press button 2 or 3 until the
mileage recorder resets to zero.
Resetting the journey
parameters (reset button)
With one of the trip parameters selected
as the display, press and hold button 2
or 3 until the display resets
Interpreting some of the
values displayed after
resetting
The values showing average fuel consumption,
range and average speed
will become more stable and reliable
the further you travel after pressing the
reset button.
For the first few miles after pressing
the reset key you will notice that the
range increases as you travel. This
range takes into account the average
fuel consumption since the last time the
reset button was pressed. Therefore,
the average fuel consumption may decrease
when:
- the vehicle stops accelerating;
- the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
- when driving from an urban area
onto the open road.
Automatic resetting of the
journey parameters
Resetting occurs automatically when
the maximum value of any of the parameters is exceeded.
READ NEXT:
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip
Information messages
These can help in the vehicle starting phase, or give information about a
selection or a driving status.
Examples of information messages are given in the following pages.
SEE MORE:
Your vehicle has been designed with
respect for the environment in mind for
its entire service life: during production,
use and at the end of its life.
This commitment is illustrated by the of
the manufacturer eco² signature.
Manufacture
Your vehicle has been manufactured at
a factory
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
Shift the selector lever to third gear.
Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
Use a strap (2) to immobilise the lever against the
shim
© 2016-2024 Copyright Renault Clio Owners Club