Fig. 135 Button for setting the tyre inflation pressure control value
System settings
A system configuration must be run as follows after adjusting the tyre pressure, after changing one or more wheels, changing the position of a wheel on the vehicle (e.g. swapping the wheels between the axles) or when the warning light lights up while driving.
If the warning light lights up
and does not go out after the system configuration,
this indicates a system fault.
If the warning light flashes ,
there is a system fault.
Tyre pressure indicator
The warning light lights up when
any of the following conditions are true.
WARNING
CAUTION
Peugeot 208. Moving off
Apply the parking brake.
Select position P or N.
Start the engine.
If this procedure is not followed, there is an audible signal, accompanied by
the display of an warning message.
With ...
Chevrolet Sonic. Detecting the Vehicle Ahead
The green vehicle ahead indicator will appear when a vehicle is detected ahead.
Whenever this indicator does not appear, FCA will not respond. The indicator may
disappear on curves, highway exit ...
Renault Clio. Trip computer and warning system
Information messages
These can help in the vehicle starting phase, or give information about a
selection or a driving status.
Examples of information messages are given in the following pages.
...