Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).
The ignition must be switched to ACC or ON.
Type A
Type B
CAUTION
To prevent accessory socket damage or electrical failure, pay attention to the following:
Noise may occur on the audio playback depending on the device connected to the accessory socket
Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the ignition off. If the problem is not resolved, consult an expert repairer, we recommend an Authorised Mazda Repairer.
NOTE
To prevent discharging of the battery, do not use the socket for long periods with the engine off or idling.
Mazda 2. Ignition Switch
Push Button Start Positions
The system operates only when the driver
is in the vehicle or within operational
range while the key is being carried.
Each time the push button start is pressed,
th ...
Skoda Fabia. Service Interval Display
A message concerning the kilometres and days remaining until the next
service is due is shown for about 10 seconds after the ignition is switched on
until the end of the service interval is reached. ...
Chevrolet Sonic. If Steam Is Coming from the Engine Compartment
Warning
Steam from an overheated engine can burn you badly, even if you just open
the hood. Stay away from the engine if you see or hear steam coming from it. Just
turn it off and get everyone aw ...