Nissan Micra: Drive belt
Nissan Micra Owners Manual
HR16DE engine
- Water pump pulley
- Generator pulley
- Crankshaft pulley
- Air conditioner compressor pulley (if so equipped) /Idler pulley (if so equipped)
- Manual tensioner pulley
Tension checking point
| WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. |
- Visually inspect the belt for signs of unusual wear, cuts, or fraying. If the belt is in poor condition, have it replaced or adjusted by a NISSAN dealer.
- Have the belt checked regularly for condition.
Other info:
Fiat Punto. To close the bonnet
Proceed as follows:
hold the bonnet up with one hand and, with the
other, remove rod (C) from recess (D) replace it in
its clip;
lower the bonnet at approx. 20 cm from the engine
compartme ...
Skoda Fabia. Interior lights
Interior lighting - version 1
Fig. 45 Interior lighting – version 1
Positions of sliding switch A » Fig. 45.
Switch on
Switch off (middle position)
Control by the door contact
switch
...
Skoda Fabia. Brake fluid
WARNING
The engine compartment of your car is a hazardous area. While
working in
the engine compartment, be sure to observe the following warnings
» page 139.
Do not continue
your jo ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia
© 2016-2024 Copyright www.b-auto.net 0.0098