Hold the coated parts A when removing or resetting the support rod. Avoid direct contact with the metal parts, as they may be hot immediately after the engine has been stopped.
When closing the hood, return the support rod to its original position, lower the hood to approximately 30 cm (12 in) above the latch and release it. This allows proper engagement of the hood latch.
WARNING
|
Seat Ibiza. Brief introduction
Why wear a seat belt and assume the correct sittingposition?
For the inflating airbags to achieve the best protection, the seat belt must
always be worn properly and the correct sitting position mu ...
Fiat Punto. To open the bonnet
Proceed as follows:
pull lever (A) in the direction of the arrow;
press lever (B) as shown by the arrow;
open the bonnet and release the rod (C) from its clip at the same
time. Insert the en ...
Chevrolet Sonic. Detecting the Vehicle Ahead
The green vehicle ahead indicator will appear when a vehicle is detected ahead.
Whenever this indicator does not appear, FCA will not respond. The indicator may
disappear on curves, highway exit ...