WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop or collision. |
For additional information, refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections of this manual before installing a child restraint.
Do not use the lower anchors if the combined weight of the child and the child restraint exceeds 65 lbs (29.5 kg). If the combined weight of the child and the child restraint is greater than 65 lbs (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
Follow these steps to install a rear-facing child restraint using the vehicle seat belts in the rear seats:
Rear-facing – step 1
Always follow the child restraint manufacturer’s instructions.
Rear-facing – step 2
Rear-facing – step 3
Rear-facing – step 4
Rear-facing – step 5
Rear-facing – step 6
After the child restraint is removed and the seat belt fully retracted, the ALR mode (child restraint mode) is canceled.
Seat Ibiza. The importance of correct seat adjustment
Proper seat adjustment optimises the level of protection offered by seat belts
and airbags.
Your vehicle has five passenger places, two individual front seats and three
places on the rear seat. E ...
Mazda 2. Electromagnetic Compatibility
Your Mazda has been tested and certifi ed to the UNECE *1 10 regulation as
related to
electromagnetic compatibility. Radio Frequency (RF) transmitter equipment (e.g.
cellular
telephones, amateur ...
Chevrolet Sonic. Liftgate (Hatchback)
Warning
Exhaust gases can enter the vehicle if it is driven with the liftgate, hatch/trunk
open, or with any objects that pass through the seal between the body and the hatch/trunk
or liftgate. E ...