B-Class car manuals
Peugeot 208: "ISOFIX" mountings - Safety - Peugeot 208 Owners Manual

Peugeot 208: "ISOFIX" mountings

Peugeot 208 Owners Manual

Peugeot 208 / Peugeot 208 Owners Manual / Safety / "ISOFIX" mountings

Your vehicle has been approved in accordance with the new ISOFIX regulation .

The seats, represented below, are fitted with regulation ISOFIX mountings:



There are three rings for each seat:

- two rings A , located between the vehicle seat back and cushion, indicated by a label,


- a ring B behind the seat for fixing the upper strap, referred to as the T op Tether.

This ISOFIX mounting system provides fast, reliable and safe fitting of the child seat in your vehicle.

When fitting an ISOFIX child seat to the left hand rear seat, before fitting the seat, first move the centre rear seat belt towards the middle of the vehicle, so as to avoid the seat interfering with the operation of the seat belt. The ISOFIX child seats are fitted with two latches which are secured on the two rings A. Some seats also have an upper strap, known as the Top Tether, which is attached to ring B. To attach this strap, raise or remove the vehicle seat's head restraint then pass the strap over the backrest. Attach the strap by its hook on ring B and then fully tighten the upper strap.

The incorrect installation of a child seat in a vehicle compromises the child's protection in the event of an accident.

For information regarding the ISOFIX child seats which can be installed in your vehicle, refer to the table showing the locations for installing ISOFIX child seats.

    Advice on child seats

    ISOFIX child seats recommended by PEUGEOT and approved for your vehicle

    Other info:

    Chevrolet Sonic. Radio Frequency Statement
    This vehicle has systems that operate on a radio frequency that comply with Part 15 of the Federal Communications Commission (FCC) rules and with Industry Canada Standards RSS‐GEN/210/220/31 ...

    Nissan Micra. Hood
    Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly. Locate the lever 2 in between the hood and grille and push the lever sideways ...

    Chevrolet Sonic. License Plate Lamp
    Lamp Assembly Bulb Assembly 1. Bulb Socket 2. Bulb 3. Lamp Assembly To replace one of these bulbs: 1. Push the left end of the lamp assembly toward the right. 2. Turn the lamp assembly down ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0123