Renault Clio: Speed limiter

Renault Clio. Speed limiter


The speed limiter function helps you stay within the driving speed limit that you choose, known as the limit speed.

Controls

Renault Clio. Controls


  1. Main “On/Off” switch.
  2. Limit speed activation, storage and increase switch (+).
  3. Decreasing the limit speed (-).
  4. Activation and recall of memorised limit speed (R).
  5. Speed limiter function standby (with limited speed memory) (O).

Switching on

Renault Clio. Switching on


Press the side switch 1 . The
indicator light 6 comes on, lit orange, and the message “SPEED LIMITER” appears on the instrument panel, accompanied by dashes to indicate that the speed limiter function is activated and waiting to store a limited speed.

To store the current speed, press switch 2 (+): the limit speed will replace the dashes.

The minimum stored speed is 20 mph (30 km/h).

Driving

Renault Clio. Driving


When a limited speed has been stored and this speed is not reached, driving is similar to driving a vehicle without the speed limiter function.

Once you have reached the stored speed, no effort on the accelerator pedal will allow you to exceed the programmed speed except in an emergency (refer to information on “Exceeding the limit speed”).

Varying the limit speed

The limit speed may be changed by repeatedly pressing:

The speed limiter function is in no way linked to the braking system.

Exceeding the limit speed

It is possible to exceed the limit speed at any time. To do this: press the accelerator pedal firmly and fully (beyond the resistance point).

While the speed is being exceeded, the programmed speed displayed on the instrument panel flashes.

Then, release the accelerator: the speed limiter function will return as soon as you reach a speed lower than the stored speed.

Limited speed cannot be maintained

If driving up or down a steep gradient, the system is unable to maintain the limit speed: the stored speed will flash on the instrument panel information display to inform you of this situation

Putting the function on standby

Renault Clio. Putting the function on standby


The speed limiter function is suspended when you press switch 5 (O). In this case, the speed limit remains stored and the message “MEMORISED” accompanied by this speed appears on the instrument panel.

Recalling the limit speed

If a speed has been saved, it can be recalled by pressing switch 4 ((R)).

When the speed limiter is put on standby, pressing switch 2 (+) reactivates the function without taking into account the stored speed: it is the speed at which the vehicle is moving that is taken into account.

Switching off the function

Renault Clio. Switching off the function


The speed limiter function is deactivated if you press switch 1: in this case a speed is no longer stored. The orange instrument panel warning light goes out, confirming that the
function is stopped.

READ NEXT:

 Cruise control

The cruise control function helps you to maintain your driving speed at a speed that you choose, called the cruising speed. This cruising speed may be set at any speed above 20 mph (30 km/h

 Parking sensor

Operating principle Ultrasonic detectors, installed in the rear bumper (depending on the vehicle), measure the distance between the vehicle and an obstacle whilst reversing. This measurement is

 Reversing camera

Operation Moving into reverse gear, the 1 camera (located on the tailgate on five-seater versions or near the number plate lights on estate versions) provides a view of the area behind the ve

SEE MORE:

 K9K, and 766 or 768

IMPORTANT Wear protective gloves during the operation. WARNING Never rotate the engine anti-clockwise (timing end). WARNING Do not run the engine without the accessories belt so as not to damage the crankshaft accessories pulley. I - PARTS TO BE SYSTEMATICALLY REPLACED the timing belt, the timin

 Turbocharger: Removal - Refitting

K9K, and 750 or 752 or 764 or 766 or 768 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the engine cover, the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery),

© 2016-2024 Copyright Renault Clio Owners Club