Renault Clio: Steering wheel/Power-assisted steering

Adjusting the steering wheel height and depth

Renault Clio. Adjusting the steering wheel height and depth


Pull lever 1 and place the steering wheel in the required position; push the lever beyond the point of resistance to lock the steering wheel in place.

Make sure that the steering wheel is correctly locked.

For safety reasons, only adjust the steering wheel when the vehicle is stationary.

Power Assisted Steering

Never drive with an inadequately charged battery.

Variable power assisted steering

The variable power assisted steering system is equipped with an electronic control system which alters the level of assistance to suit the vehicle speed.

Steering is made easier during parking manoeuvres (for added comfort) whilst the force needed to steer increases progressively as the speed rises (for enhanced safety at high speeds).

Never leave the steering wheel at full lock while stationary.

With the engine switched off, or if there is a system fault, it is still possible to turn the steering wheel. The force required will be greater.

Never switch off the ignition when travelling downhill, and avoid doing so in normal driving (assistance is not provided).

READ NEXT:

 Driving position

 Left-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY. Side air vent. Stalk for: direction indicator lights; exterior lights; front fog lights; rear fog light

 Right-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY. Side air vent. Passenger Airbag location. Heating or air conditioning controls. Multimedia touch-screen. Wind

SEE MORE:

 High pressure pipe: Check

K9K WARNING After any operation, check that there are no diesel fuel leaks Reprime the diesel circuit using the priming pump. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the engine protector. Disconnect the inlet air pressure sensor (1) Remove

 Silencer: Removal - Refitting

D4F or K4J or K4M or K9K or M4R REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Cut the exhaust pipe (see 19B, Exhaust, Exhaust: Precautions for the repair, 19B-19) (see ) (MR 392, 19A, Exhau

© 2016-2024 Copyright Renault Clio Owners Club