Renault Clio: Tools
The tools included in the tool kit depend on the vehicle.
Tool kit A is located in the tray under the luggage compartment carpet.
Lift the cover and remove it.
Wheelbrace 1
Locks or unlocks the wheel bolts and tow eye 5
Jack 2
Fold it correctly before refitting it in its housing (ensure that the wheelbrace is correctly positioned).
Hubcap tool 3
This tool is used to remove the wheel trims.
Wheel bolt guide 4
To finish loosening or starting to tighten the wheel bolts.
Tow eye 5
Please see “Towing: breakdown recovery” in Section 5.
Lever 6
This tightens or releases the tow eye 5.
| Do not leave the tools unsecured inside the vehicle as they may come
loose under braking. After use, check that all the
tools are correctly clipped into the tool kit, then position it
correctly in its housing: there is a risk of injury. If wheel bolts are supplied in the tool kit, only use these bolts for the emergency spare wheel: refer to the label affixed to the emergency spare wheel. The jack is designed for wheel changing purposes only. Under no circumstances should it be used for carrying out repairs underneath the vehicle or to gain access to the underside of the vehicle. |
READ NEXT:
Wheel trims - wheel
Remove the wheel trim using hubcap
tool 1 (located in the tool kit) by engaging
the hook in the opening near
valve 2.
To refit it, align it with valve 2. Push the
retaining hooks in fully,
Changing a wheel
Switch on the hazard warning
lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or
Tyres (tyre and wheel safety, use in winter)
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway
SEE MORE:
Diesel injector: Configurations
K9K, and 750 or 752 or 766 or 768
To configure the injectors, (see MR 394 Fault finding,
Diesel Injection, Configuration and programming).
Diesel injector: Removal - Refitting
K9K, and 764 or 772
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions
Windscreen: Removal - Refitting
WARNING
Leave the rain sensor in place on the old windscreen
during the replacement operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the scuttle panel grille (see 56A, Exterior equipment,
Scuttle panel grille: Removal - Refitting, 56A-1),
the windscreen trims (see 54A, Windows,
