Renault Clio: Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
- The rear bench seatback for normal
loads (example A).
- The front seatbacks with the rear
seatbacks folded down, as is the case
for maximum loads (example B).
If you have to place objects on the folded
seatback, it is necessary that you lower
the headrests before folding the seatback
so that it can be folded as flat as
possible against the seat.
Always position the heaviest
items directly on the
floor. Use the lashing
points 1 on the boot floor, if
these are fitted to the vehicle. The
luggage should be loaded in such a
way that no items will be thrown forward
and strike the occupants if the
driver has to brake suddenly. Fasten
the rear seat belts, even if the seats
are not occupied. |
READ NEXT:
Permissible nose weight, maximum
permissible towing weight,
braked and unbraked: refer to
the information on “Weights” in
Section 6.
For fitting and conditions of use,
Luggage net A
On equipped vehicles, this can be used
when transporting animals or luggage,
to separate them from the passenger
section.
It can be positioned:
behind the front seats;
b
SEE MORE:
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
When replacing the multimedia network interface
unit, carry out the necessary operations using the
Diagnostic tool (see Fault finding - Replacement
of components) (86C, Multimedia network interface
unit).
Switch off the ignitio
DP0
Do not drain or remove the automatic gearbox in order
to remove the flow control solenoid valve
REMOVAL
I - REMOVAL PREPARATION OPERATION
Place the vehicle on a two-post lift (see 02A, Lifting
equipment, Vehicle: Towing and lifting).
Disconnect the battery (see 80A, Battery, Battery:
Remov
© 2016-2024 Copyright Renault Clio Owners Club