The towing device should be fastened to the body by specialised personnel according to any additional and/or integrative information supplied by the Manufacturer of the device.
The towing device must meet current regulations with reference to 94/20/EC Directive and subsequent amendments.
For any version the towing device used must match the towable weight of the vehicle on which it is to be installed.
For the electric connection a unified connector should be used which is generally placed on a special bracket normally fastened to the towing device, and a special ECU for external trailer light control shall be installed on the car.
For the electrical connection, a 7 or 13 pole 12ESP coupling must be used (CUNA/UNI and ISO/DIN standards). Follow the instructions provided by the car manufacturer and/or the tow hitch manufacturer.
An electric brake should be supplied directly by the battery through a cable with a cross section of no less than 2,5 mm2.
IMPORTANT Electric brake or other device shall be used with running engine.
In addition to the electrical branches, the car’s electric system can only be connected to the supply cable for an electric brake and to the cable for an internal light, though not above 15W.
For connections use a preset control unit with battery cable no less than 2,5 mm2.
Assembly diagram
The tow hook structure must be fastened in the points
shown by the symbol using a total of 4 M8 screws 2
M10 screws and 2 M12 screws.
In the fastening points of the rear external covering, the dampening pad fastening plates must be replaced with right plate A and left plate B (code 50901257 and 50901258) that shall compulsorily be mounted in the external side of the rear covering, as shown in the figure.
The hook should be fastened to the body avoiding any type of drilling and trimming of the rear bumpers that remains visible when the hook is removed.
IMPORTANT It is compulsory to fasten a label (plainly visible) of suitable size and material with the following wording:
MAX LOAD ON BALL 60 kg
After fitting, screw
holes shall be sealed to prevent an exhaust gas inlet. |
Mazda 2. Fuel and Engine Exhaust Precautions
Fuel Requirements (SKYACTIV-G 1.3, SKYACTIV-G 1.5)
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED
FUEL,
which will reduce exhaust emissions and keep spark plug fouling ...
Peugeot 208. Battery
Procedure for charging your battery when it is flat or for starting the engine
using another battery.
The presence of this label indicates the use of a 12 V lead-acid battery with
special techn ...
Mazda 2. Dynamic Stability Control (DSC)
The Dynamic Stability Control (DSC)
automatically controls braking and engine
torque in conjunction with systems such
as ABS and TCS to help control side slip
when driving on slippery surfaces, or ...