FASTENERS
3-door versions
Move the seal aside in the points shown in the figure to reach the fasteners.
The rear fasteners are in the areas indicated by the printed
reference
mark on the rear side windows.
To make use of the presetting couplings, remove the retainer (A) by operating on the relevant catch as shown in the figure.
5-door versions
Move the seal aside in the points shown in the figure to reach the fasteners.
The rear fasteners are in the areas indicated by the printed reference mark on the rear side windows.
Attach the roof rack brackets to the fasteners.
To make use of the presetting couplings, remove the retainer (A) by operating on the relevant catch as shown in the figure.
After few kilometers, check that fastening screws are firmly tightened.
IMPORTANT Follow the instructions provided in the kit to the letter for both versions (3 and 5 doors).
Fitting should be entrusted to skilled personnel.
IMPORTANT Never exceed the max. permissible loads (see section “Technical specifications”).
Honda Fit. Ignition Switch
Manual transmission models
WARNING
Removing the key from the ignition switch
while driving locks the steering. This can
cause you to lose control of the vehicle.
Remove the key from the ignit ...
Honda Fit. Light Switches
Rotating the light switch turns the lights on
and off, regardless of the position of the
ignition switch.
■ High beams
Push the lever forward until you hear a click.
■ Low beams ...
Fiat Punto. Air cleaner
REPLACING THE FILTER
1.28V version
Loosen the screws on the side and on the air cleaner cover, remove the
cover (A) and remove the filtering element (B) to be replaced.
1.3 Multijet versio ...