NOTE
Changing the engine oil should be done by an expert repairer, we recommend an Authorised Mazda Repairer.
Recommended Oil
In order to keep the maintenance interval (page 6-3 ) and to protect the engine from damage caused by poor lubrication, it is vitally important to make use of engine oil with the correct specifi cation. Do not use oils which do not meet the below specifi cation or requirements.
Use of unsuitable oil may lead to engine damage which is not covered by the Mazda Warranty.
Europe
Except Europe
*1 LP : Low-Power
*2 For African nations, use SL or higher engine oil with the SKYACTIV-G 1.3 and SKYACTIV-G 1.5 LP (Low-Power) engines.
*1 MP : Medium-Power
*2 HP : High-Power
Engine oil viscosity, or thickness, has an effect on fuel economy and cold-weather operation (starting and oil fl ow).
Low-viscosity engine oils can provide improved fuel economy and cold-weather performance.
When choosing an oil, consider the temperature range your vehicle will operate in before the next oil change.
Then select the recommended viscosity from the chart above.
CAUTION
NOTE
(SKYACTIV-G 1.3 and SKYACTIV-G 1.5)
Engine oil consumption may be as high as 0.8 L/1000 km (1 L/800 miles). This may be as a result of evaporation, internal ventilation or burning of the lubricating oil in the working engine. Oil consumption may be higher when the engine is new due to the running-in process. Oil consumption is also dependant on engine speed and engine load. Under extreme driving conditions, oil consumption may be higher.
(SKYACTIV-D 1.5)
Inspect the engine oil level periodically. When inspecting the engine oil, if the engine oil level is exceeds the “X” mark on the dipstick, replace the engine oil. This should be done by an expert repairer, we recommend an Authorised Mazda Repairer. When replacing the engine oil, inspect the oil level using the oil dipstick and refi ll so that the engine oil level is within the range between Full to Low as shown in the fi gure.
Vehicle Engine Control Unit Reset Procedure
After replacing the engine oil, have a repair shop such as an Authorised Mazda Repairer perform the initialization (engine oil data resetting) of the recorded value. If the value recorded by the computer is not initialized, the wrench indicator light may not turn off or it may turn on earlier than normal.
NOTE
The initialization (engine oil data resetting) of the recorded value can be performed using the following procedure:
Inspecting Engine Oil Level
SKYACTIV-G 1.3 and SKYACTIV-G 1.5
SKYACTIV-D 1.5
NOTE
(SKYACTIV-D 1.5) When inspecting the engine oil level, pull out the dipstick straight without twisting. In addition, when inserting the dipstick, always insert it without twisting so that the “X” mark faces the front of the vehicle.
The level is normal if it is between Low and Full.
If it is near or below Low, add enough oil to bring the level to Full.
CAUTION
Do not overfi ll the engine oil. This may cause engine damage.
Mazda 2. Vent Operation
Adjusting the Vents
Directing airfl ow
To adjust the direction of airfl ow, move the
adjustment knob.
NOTE
When using the air conditioner under
humid ambient temperature conditions,
the system ...
Renault Clio. Boot
To open
Press button 1 and lift the tailgate.
To close
Lower the tailgate using the handles 2
inside the tailgate to help you
Opening the doors manually from the inside
If it is impossib ...
Chevrolet Sonic. Winter Tires
This vehicle was not originally equipped with winter tires. Winter tires are
designed for increased traction on snow and ice-covered roads. Consider installing
winter tires on the vehicle if frequ ...