Mazda 2: Starting a Flooded Engine (SKYACTIV-G 1.3 and SKYACTIV-G 1.5 )
Mazda2 Owners Manual
If the engine fails to start, it may be fl ooded (excessive fuel in the engine).
Follow this procedure:
- If the engine does not start within fi ve seconds on the fi rst try, wait ten seconds and try again.
- Make sure the parking brake is on.
- Depress the accelerator all the way and hold it there.
- Depress the clutch pedal (Manual transaxle) or the brake pedal (Automatic transaxle), then press the push button start. If the engine starts, release the accelerator immediately because the engine will suddenly rev up.
- If the engine fails to start, crank it without depressing the accelerator.
If the engine still does not start using the above procedure, have your vehicle inspected by an expert repairer, we recommend an Authorised Mazda Repairer.
Other info:
Fiat Punto. Diesel fuel filter
DRAINING THE CONDENSE (diesel versions)
The presence of water
in the fuel circuit may cause serious damage to the entire injection
system
and cause irregular engine operation. ...
Fiat Punto. General instructions
When a light is not working, check that the
corresponding fuse is intact before changing a bulb.
For the location of fuses, refer to the paragraph “If
a fuse blows” in this section;
Bef ...
Mazda 2. Parking Sensor System
The parking sensor system uses ultrasonic sensors to detect obstructions
around the vehicle
while parking the vehicle in a garage or during parallel parking when the shift
lever is
in reverse (R ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia
