
Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the gross axle weight ratings (GAWR). The total of the axle loads should not exceed the gross vehicle weight rating (GVWR). These ratings are given on the vehicle certification label. If weight ratings are exceeded, move or remove items to bring all weights below the ratings.
Mazda 2. Drive Selection
Drive selection is a system to switch the vehicle's drive mode. When the
sport mode is
selected, vehicle's response against accelerator operation is enhanced. Use the
sport mode
when higher vehi ...
Nissan Micra. Rear-facing child restraint installation using
LATCH
For additional information, refer to all Warnings
and Cautions in the “Child safety” and “Child
restraints” sections of this manual before installing
a child restraint.
Do not use the lo ...
Honda Fit. Automatic Transmission
■Creeping
The engine may run at a higher idle speed and creeping increases:
• Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal f ...