WARNING
CAUTION
For the sake of the environment
At high speeds, you should keep the windows closed to prevent unnecessarily high fuel consumption.
Note
Opening/closing the windows
Fig. 37 Buttons on the driver's door/in the rear doors
Power window buttons » Fig. 37.
S. Safety pushbutton
The electrical power windows can only be operated when the ignition is switched on.
Opening
The window will also open fully automatically if you briefly press the button as far as the stop. Renewed pressing of the button causes the window to stop immediately.
Closing
The window will also close fully automatically if you briefly pull the button as far as the stop. Renewed pulling of the button causes the window to stop immediately.
Safety pushbutton
The buttons for power windows in the rear doors can be deactivated by pressing the safety switch S » Fig. 37. The buttons for the electrical power windows in rear doors are activated again by pressing the safety pushbutton S again.
If the buttons for the rear doors are deactivated, the warning light
in the
safety switch S lights up.
Note
The window lift mechanism is equipped with protection against overheating.
Repeated opening and closing of the window can cause this mechanism to overheat. If this happens, it will not be possible to operate the window for a short time. You will be able to operate the window again as soon as the overheating protection has cooled down.
Power window force limiter
The electrical power windows are fitted with a force limiter. It reduces the risk of bruises or injuries when closing the windows.
If there is an obstacle, the closing process is stopped and the window goes down by several centimetres.
If the obstacle prevents the window from being closed during the next 10 seconds, the closing process is interrupted once again and the window goes down by several centimetres.
If you attempt to close the window again within 10 seconds of the window being moved down for the second time, even though the obstacle was not yet been removed, the closing process is only stopped. During this time it is not possible to automatically close the window. The force limiter is still switched on.
The force limiter is only switched off if you attempt to close the window again within the next 10 seconds - the window will now close with full force! If you wait longer than 10 seconds, the force limiter is switched on again.
Window convenience operation
The comfort controls of the windows provide the ability to open or close all the windows at once.
Opening can take place in one of the following ways.
Opening
Closing
The movement of the window is immediately stopped by releasing the key or the respective button.
Operational faults
Electrical power windows do not operate
If the battery has been disconnected and then reconnected while the window was opened, the electrical power windows will not operate. The system must be activated. Proceed as follows to re-establish the function.
Operation in winter
In the winter, ice on the window may cause greater resistance as the window is closed. The window will stop and open again by several centimetres.
It is necessary to deactivate the force limiter to close the window » page 53.
Nissan Micra. When traveling or registering in another country
When planning to drive your NISSAN vehicle
in another country, you should first find
out if the fuel available is suitable for your vehicle’s
engine.
Using fuel with an octane rating that is t ...
Peugeot 208. Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition
is switched on, this code must be recognised in order for starting to be possible.
Thi ...
Nissan Micra. Starting the engine
Apply the parking brake.
Automatic transmission:
Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The shift lever cannot be moved out of
the P (Park) position and ...