B-Class car manuals
Peugeot 208: Changing a fuse - Changing a fuse - Practical information - Peugeot 208 Owners Manual

Peugeot 208: Changing a fuse

Peugeot 208 Owners Manual

Before changing a fuse:

  • the cause of the failure must be identified and rectified,
  • all electrical consumers must be switched off,
  • the vehicle must be immobilised with the ignition off,
  • identify the failed fuse using the tables and layout drawings in the following pages.

To replace a fuse, you must:

  • use the special tweezer to extract the fuse from its housing and check the condition of its filament.
  • always replace the failed fuse with a fuse of the same rating (same colour); using a different rating could cause faults (risk of fire).

If the fuse fails again soon after replacement, have the vehicle's electrical system checked by a PEUGEOT dealer or a qualified workshop.


Good


Failed


Tweezer

The replacement of a fuse not shown in the tables below may cause a serious malfunction of your vehicle. Contact a PEUGEOT dealer or a qualified workshop.

Installing electrical accessories

Your vehicle's electrical system is designed to operate with standard or optional equipment.

Before installing other electrical equipment or accessories on your vehicle, contact a PEUGEOT dealer or a qualified workshop.

PEUGEOT will not accept responsibility for the cost incurred in repairing your vehicle or for rectifying malfunctions resulting from the installation of accessories not supplied and not recommended by PEUGEOT and not installed in accordance with its instructions, in particular when the combined consumption of all of the additional equipment connected exceeds 10 milliamperes.

    Access to the tools

    Fuses in the dashboard

    Other info:

    Nissan Micra. Difference between predicted and actual distances
    The displayed guidelines and their locations on the ground are for approximate reference only. Objects on uphill or downhill surfaces or projecting objects will be actually located at distances ...

    Peugeot 208. Operating fault
    With the ignition on, if this warning lamp comes on and AUTO flashes, accompanied by an audible signal and a message in the screen, this indicates a gearbox fault. Have it checked by a PEUGEOT d ...

    Nissan Micra. Drive belt
    HR16DE engine Water pump pulley Generator pulley Crankshaft pulley Air conditioner compressor pulley (if so equipped) /Idler pulley (if so equipped) Manual tensioner pulley Tensi ...

    Manuals For Car Models



    В© 2016-2020 Copyright www.b-auto.net 0.0185