Move the lever all the way up or down to signal a turn.
An arrow on the instrument cluster will flash in the direction of the turn or lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever is briefly pressed and released, the turn signal flashes three times.
The lever returns to its neutral position when it is released.
If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb may be burned out. Replace any burned out bulbs. If a bulb is not burned out, check the fuse. See Fuses and Circuit Breakers or Bulb Replacement.
Turn Signal On Chime
If the turn signal is left on for more than 1.2 km (0.75 mi), a chime will sound at each flash of the turn signal. To turn the chime off, move the turn signal lever to the neutral position.
Fiat Punto. Identification data
You are advised to note the identification codes. The identification data
stamped and given on the plates and their position are the following:
Model plate
Chassis marking
Bodywork paint ...
Peugeot 208. Operating fault
In the event of a fault
with the sunshine sensor, the lighting comes on, this warning lamp is displayed
in the instrument panel and/or a message appears in the screen, accompanied by an
audible ...
Fiat Punto. Jump starting
If the battery is flat, it is possible to start the engine using an auxiliary
battery with the same capacity or a little higher than the flat one.
Proceed as follows:
Connect positive terminal ...