B-Class car manuals
Peugeot 208: Dynamic stability control (DSC) - ESP system - Safety - Peugeot 208 Owners Manual

Peugeot 208: Dynamic stability control (DSC)

Peugeot 208 Owners Manual

Peugeot 208 / Peugeot 208 Owners Manual / Safety / ESP system / Dynamic stability control (DSC)

Activation

This system is activated automatically each time the vehicle is started.

It comes into operation in the event of a grip or trajectory problem.

This is indicated by flashing of
this warning lamp in the instrument panel.

Deactivation

In exceptional conditions (starting a vehicle which is bogged down, stuck in snow, on soft ground...), it may be advisable to deactivate the DSC system, so that the wheels can move freely and regain grip.


But it is recommended that the system be reactivated as soon as possible.

Press the switch.

The indicator lamp in the switch comes on: the DSC system no longer acts on the operation of the engine.


Reactivation

The system is reactivated automatically each time the ignition is switched back on or from 30 mph (50 km/h).

Press the switch again to reactivate it manually.

Operating fault


If this warning lamp comes on, accompanied by an audible signal and a message in the screen, this indicates a fault with the system. Contact a PEUGEOT dealer or a qualified workshop to have the system checked.

The DSC system offers exceptional safety in normal driving, but this should not encourage the driver to take extra risks or drive at high speed. The correct operation of the system depends on observation of the manufacturer's recommendations regarding the wheels (tyres and rims), the braking components, the electronic components and the PEUGEOT assembly and operation procedures. After an impact, have the system checked by a PEUGEOT dealer or a qualified workshop.

    Operation

    Seat belts

    Other info:

    Skoda Fabia. Foglights and daytime running lights
    Fig. 158 Front bumper: Protective grille/removing the fog light Bulb location В» Fig. 158. Bulb for daylight driving light Light bulb for fog lights Removing the cap Grasp the protectiv ...

    Fiat Punto. Refitting the standard wheel
    Proceed as follows: Following the procedure described previously, raise the car and remove the spare wheel; Make sure the contact surfaces between wheel and hub are clean so that the fas ...

    Manuals For Car Models



    В© 2016-2019 Copyright www.b-auto.net