To engage the gears, press the clutch pedal fully and shift the gear lever into one of the required positions (the diagram is shown on the knob).
IMPORTANT The car can only be put into reverse gear when it has stopped moving completely. With the engine running, before engaging the reverse, wait at least 2 seconds with the clutch pedal fully down to prevent damage and grating of the gears.
To engage reverse (R) from neutral proceed as follows:
To change gears properly
you must push the clutch pedal fully down. It is therefore essential that there is nothing under the pedals: make sure mats are lying flat and do not get in the way of the pedals. |
Do not drive with your
hand resting on the gear lever as the force exerted, even if slight, could lead over time to premature wear on the gearbox internal components. |
Peugeot 208. Manual gear changing
This selective gear change mode enables you to overtake, for example, while still
remaining in automatic mode.
Operate the + or - steering mounted control paddle.
The gearbox engages the gear re ...
Chevrolet Sonic. Selecting a Station
Seek Tuning
If the radio station is not known:
Briefly press SEEK or
SEEK to automatically search for the
next available station. If a station is not found, the radio switches to a more
sensi ...
Mazda 2. i-stop
The i-stop function automatically stops the engine when the vehicle is
stopped at a traffi c
light or stuck in traffi c, and then restarts the engine automatically to resume
driving. The
system ...