NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the windshield, becoming stuck.
Operating the wipers in this condition may damage the wipers. Use the defroster to warm the windshield, then turn the wipers on.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Front Wiper/Washer
The windshield wipers and washers can be used when the ignition switch is in ON .
■ MIST
The wipers run at high speed until you release the lever.
■ Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to the amount of rain.
■ Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make two or three more sweeps before stopping.
Rear Wiper/Washer
The rear wiper and washer can be used when the ignition switch is in ON .
■ Wiper switch (OFF, ON)
The wiper operates intermittently after completing a few sweeps.
■ Washer ( )
Sprays while you rotate the switch to this
position.
Hold it to activate the wiper and to spray the washer. Once released, it stops operating after a few more sweeps.
■ Operating in reverse
When you shift the transmission to
with the front wiper activated, the rear wiper
operates automatically as follows even if its switch is off.
If the wiper stops operating due to any obstacle such as the build-up of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY or LOCK
, then remove
the obstacle.
The wiper motor is equipped with a breaker that may stop motor operation temporarily to prevent an overload. Wiper operation will return to normal within a few minutes, once the circuit has returned to normal.
Honda Fit. Changing the Front Wiper Blade Rubber
1. Lift the driver side wiper arm first, then the
passenger side.
2. Place a cloth on the edge of the lock tab.
Push the lock tab up with a flat-tip
screwdriver.
3. Slide the blade from the ...
Honda Fit. Manual transmission models Shifting
■Shift Lever Operation+
Fully depress the clutch pedal to operate the shift lever and change gears,
then
slowly release the pedal.
Depress the clutch pedal, and pause for a few seconds be ...
Skoda Fabia. Parking aid
WARNING
The parking aid is not a substitute for the driver paying
proper attention
and it is always the driver's responsibility to take care when reversing the
vehicle or carrying out simil ...