Due to legal requirements in some Canadian Provinces, your vehicle may be required to be in what is called the “ready condition” for an Inspection/Maintenance (I/M) test of the emission control system.
The vehicle is set to the “ready condition” when it is driven through certain driving patterns. Usually, the ready condition can be obtained by ordinary usage of the vehicle.
If a powertrain system component is repaired or the battery is disconnected, the vehicle may be reset to a “not ready” condition. Before taking the I/M test, check the vehicle’s inspection/maintenance test readiness condition.
Place the ignition switch in the ON position without starting the engine. If the Malfunction Indicator Light (MIL) comes on steady for 20 seconds and then blinks for 10 seconds, the I/M test condition is “not ready”. If the MIL does not blink after 20 seconds, the I/M test condition is “ready”. Contact a NISSAN dealer to set the “ready condition” or to prepare the vehicle for testing.
Seat Ibiza. Interior lights
Front interior light
Fig. 62 Interior roof trim: front interior lights
The switch ⇒ fig. 62 is used to select the following positions:
Courtesy light position
Sliding switch in central po ...
Chevrolet Sonic. Recreational Vehicle Towing
Recreational vehicle towing means towing the vehicle behind another vehicle,
such as a motor home. The two most common types of recreational vehicle towing are
known as dinghy towing and dolly tow ...
Honda Fit. Transmission Fluid
Automatic Transmission Fluid
Specified fluid: Honda ATF DW-1 (automatic transmission fluid)
Check the fluid level when the engine is at normal operating temperature.
1. Park on level ground, and ...