Your vehicle has been approved in accordance with the new ISOFIX regulation .
The seats, represented below, are fitted with regulation ISOFIX mountings:
There are three rings for each seat:
- two rings A , located between the vehicle seat back and cushion, indicated by a label,
- a ring B behind the seat for fixing the upper strap, referred to as the T op Tether.
This ISOFIX mounting system provides fast, reliable and safe fitting of the child seat in your vehicle.
When fitting an ISOFIX child seat to the left hand rear seat, before fitting the seat, first move the centre rear seat belt towards the middle of the vehicle, so as to avoid the seat interfering with the operation of the seat belt. The ISOFIX child seats are fitted with two latches which are secured on the two rings A. Some seats also have an upper strap, known as the Top Tether, which is attached to ring B. To attach this strap, raise or remove the vehicle seat's head restraint then pass the strap over the backrest. Attach the strap by its hook on ring B and then fully tighten the upper strap.
The incorrect installation of a child seat in a vehicle compromises the child's protection in the event of an accident.
For information regarding the ISOFIX child seats which can be installed in your vehicle, refer to the table showing the locations for installing ISOFIX child seats.
Mazda 2. SRS Air Bag Deployment Criteria
This chart indicates the applicable SRS equipment that will deploy depending
on the type of
collision.
(The illustrations are the representative cases of collisions.)
X : The SRS air bag eq ...
Peugeot 208. Operating fault
When the ignition is on, the lighting
of this warning lamp, accompanied by an audible signal and a message in the multifunction
screen, indicates a gearbox fault.
In this case, the gearbox switc ...
Nissan Micra. Cleaning
If your windshield is not clear after using the
windshield–washer or if a wiper blade chatters
when running, wax or other material may be on
the blade or windshield.
Clean the outside of the w ...