Peugeot 208: Programming
Peugeot 208 Owners Manual
Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE).
Set the programmed speed by accelerating to the required speed, then press button 2 or 3 (e.g.: 70 mph (110 km/h)).
You can then change the programmed speed using buttons 2 and 3:
- by + or - 1 mph (km/h) = short press, - by + or - 5 mph (km/h) = long press, - in steps of + or - 5 mph (km/h) = maintained press.
Switch off the cruise control by pressing button 4 : the screen confirms that it has been switched off (PAUSE).
Switch the cruise control back on by pressing button 4 again.
Other info:
Mazda 2. Parking in an Emergency
Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway in an emergency.
The hazard warning lights warn other
drivers that your vehicle is ...
Nissan Micra. Tire labeling
Example
Federal law requires tire manufacturers to
place standardized information on the
sidewall of all tires. This information identifies
and describes the fundamental
characteristics of th ...
Citroen C3. Checking levels
Check all of these levels regularly and
top them up if necessary, unless otherwise
indicated.
If a level drops signifi cantly, have the
corresponding system checked by a
CITROËN dealer.
...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia
